Kalfire Gi105/59F User Instructions page 16

ATTENTION!
For programmable functions (which are mostly temperature-controlled), it is
important to place the remote control in a place where you want the desired
temperature to be reached. The temperature sensor is inside the remote
control.
Thermostat function
The thermostat function of the Kalfire Gi can be used to quickly heat the room
in which the fireplace is set up. After all, it is not always necessary to heat the
entire house or turn on the underfloor heating. Via the app, the desired end
temperature can be specified in thermostat mode. The fireplace does the rest. If
the desired temperature is reached, the fireplace turns off. When the
temperature has dropped 1.5 degrees below the desired end temperature, the
fireplace comes back on.
Factory setting thermostat function: end temperature: 21°C
CAUTION!
After going through the start-up cycle, the fireplace takes over the last settings
used. If this is the thermostat function and the temperature in the room is
higher or equal to the selected end temperature, the fireplace will switch off
after completing the start-up cycle.
Comfort+ Function
Determine the maximum temperature rise and the time it should take the stove
to reach this temperature. Also thanks to the three separately controlled gas
valves, the flame image remains lively and beautiful. Adjustable via the
ConnectedApp.
Factory setting Comfort+: end temperature: 21°C, time: 240 minutes
Moods
With the Moods function, different functions can be recorded together. For
example, if the Comfort+ function in combination with setting 3 of the NSG
and setting 4 of the EmberGlow function is your favourite setting, you can
record this in your personal Mood. Programming your own Moods is only
possible via the Kalfire ConnectedApp. Via this app, up to 10 different Moods
can be programmed. Then, one push of the button is enough to activate the
desired mood. With the remote control, 3 Moods can be controlled. If no
16