Intellijel Tangrams Manual page 14

[3.8] CYCLE switch - Switches the Pulser
between Single-shot and Cycle
modes.
The Pulser generates two pulses,
each with its own independent length
(as set by T1 and T2 ). PULSE 2 is
always triggered at the conclusion of
PULSE 1. Using the CYCLE switch,
you can set whether a single pulse
sequence is generated, or a cycling
pulse sequence. Specifically:
● DOWN ( "SINGLE" ) : If the CYCLE
switch is down, the Pulser does
not cycle, and a single pulse
sequence (PULSE 1 > PULSE 2 >
OFF) is triggered via the
P.TRIG IN [3.C]
by the PULSER MANUAL
TRIGGER [3.7]
information, see
Pulse / Envelope Examples
in this manual.
● UP ( "CYCLE" ) : If the CYCLE
switch is up, the Pulser will cycle
repeatedly (PULSE 1 > PULSE 2
> PULSE 1 > PULSE 2 > etc.). For more information and examples, see
Pulse Examples
NOTE: Turning on Cycling automatically starts the PULSER, without requiring a manual
or external trigger, while turning off Cycling automatically stops it. However, once the
PULSER is cycling, P.TRIG IN
reset the cycle at the beginning of PULSE 1.
jack, or manually
button. For more
SINGLE-SHOT
, later
, later in this manual.
[3.C] and/or the PULSER's MANUAL TRIGGER
Tangrams Manual
CYCLING
[3.7] will
14