Fayat Group DYNAPAC DRP70D Operating Instruction page 54

Operation – Starting the engine
Fig. 37
Fig. 38
54
3. Turn the ignition key to position "I".
ð The warning buzzer sounds.
B-ELE-0070
4.
B-ELE-0072
Turn the ignition key through position "II" to position "III".
ð The starter cranks the engine.
The warning buzzer stops.
DRP70D
The starter switch is designed with a re-start
lock. The ignition key must first be turned
back to position "0" before a new starting
attempt can be made.
NOTICE!
Components may get damaged!
– Starting attempts should not exceed 30
seconds uninterrupted or max. 3 times
for 10 seconds. Then allow the starter to
cool down to ambient temperature.
– If the engine has not started after these
attempts, determine the cause.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while
before starting work. Do not operate
the engine immediately under full
load.