l
Assembly (continued)
4
Attaching the crossbar
Attach the center lengthways bar (E) to the center of the front connector bars (A and B) using M6x75 bolts (DD) and washers (EE).
Attach the center lengthways bar (E) to the center of the back connector bars (A and B) using M6x75 bolts (DD) ,M6X15 bolts (AA )
and washers (EE).
Attach four lengthways bars (C) and two side top bars (D) to the assembled connector bars (A and B) sing M6x75 bolts (DD) ,
M6X15 bolts (AA )and washers (EE) as shown below.
Once all bolts are in place,Fully tighten all the bolts by the hex wrench (GG).
Make sure two side top bars (D) and the center lengthways bar (E) with protective cover bolt hole side to stay on the same direction
for assembly the protective cover (I) successfully,then attach to the assembled connector bar(A&B) without Magnet iron plate (K)
as shown below
Q
A
The hole is to lock the
protective cover (I)
EE
AA
L
A&B
.
DD
A
E
C
D
B
EE
D
EE
S
B
A&B
E
8
DD
EE
AA
C
B
C
DD
Q
A
K
EE
D
A
EE
AA
EE
B