Removing the I/O board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1
Remove the
base
2
Remove the battery.
3
Remove the
wireless
Procedure
1
Peel off the tape that secures the I/O-board cable to the I/O board.
2
Disconnect the I/O-board cable from the I/O board.
3
Peel off the tape that secures the power and volume-buttons board-cable to the
palm-rest assembly.
4
Disconnect the power and volume-buttons board-cable from the I/O board.
5
Disconnect the coin-cell battery-cable from the I/O board.
6
Remove the two screws (M2x3.5) that secures the I/O board to the palm-rest
assembly.
computer. After working inside your computer, follow
After working inside your
cover.
card.
computer. For more safety best
www.dell.com/
Before
61