Engine Coolant - Sea-doo SAR 2018 Series Operator's Manual

MAINTENANCE PROCEDURES
smo2011-003-010_b
TYPICAL
1. Oil filler cap location
NOTE: Every time oil is added in the
engine, the complete procedure ex-
plained in this section must be carried
out again. Otherwise, you will obtain a
false oil level reading.
9. Properly reinstall oil cap and dip-
stick.
Engine Oil Change and Oil Filter
Replacement
The oil change and filter replacement
may be performed by an authorized
Sea-Doo dealer, repair shop, or person
of your own choosing.

Engine Coolant

Recommended Engine Coolant
Always use EXTENDED LIFE PRE-
MIXED COOLANT
(P/N 779150) or equivalent. If the
recommended coolant is not avail-
able, use a low silicate, extended
life ethylene-glycol premixed coolant
(50%-50%) specifically
for internal combustion aluminum en-
gines.
To prevent antifreeze deterioration, al-
ways use the same brand and grade.
Never mix different brands or grades
unless cooling system is completely
flushed and refilled.
______________
96
(219702685)
formulated
Engine Coolant Level
WARNING
Check coolant level with engine
cold. Never add coolant in cooling
system when engine is hot.
CAUTION Certain
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn.
Open seat.
Locate the expansion tank cap.
smo2011-003-010_c
TYPICAL
1. Expansion tank cap
With watercraft on a level surface,
coolant level should be between MIN.
and MAX. marks on coolant reservoir
when engine is cold.
F18E0NY
TYPICAL - COOLANT EXPANSION TANK
1. Level between marks when engine is cold
compo-
1