Page 1
Operating and Installation Instructions Gourmet Drawer It is essential to read the operating and installation instructions be- fore setup, installation, and commissioning. This prevents both per- sonal injury and damage to the appliance. en-US M.-Nr. 11 924 070...
ESW 7010, ESW 7110..................27 ESW 7570, ESW 7580, ESW 7670, ESW 7680 ..........28 Low temperature cooking ................29 Other uses......................34 Networking with Miele Built-in Appliances ............. 35 Sabbath mode....................36 Cleaning and care ..................... 37 Frequently asked questions ................39 Optional accessories ..................
Page 3
Contents Appliance warranty and product registration ............42 Installation......................43 IMPORTANT SAFETY INSTRUCTIONS - INSTALLATION ........43 Installation notes ....................44 Installation dimensions ESW 7010, ESW 7110 ........... 45 Combination with an H 2840 or CVA/DGC/H 7x4x........45 Combination with a DGC/H 7x6x..............46 Side view ......................
“IMPORTANT SAFETY INSTRUCTIONS”. Miele cannot be held liable for injury or damage caused by non- compliance with these instructions. Keep these operating and installation instructions in a safe place...
Page 5
IMPORTANT SAFETY INSTRUCTIONS Appropriate use This drawer is intended for domestic use and use in other similar environments. The drawer is not intended for outdoor use. The warming drawer is intended for domestic use only as de- scribed in these instructions.
Page 6
IMPORTANT SAFETY INSTRUCTIONS Safety with children As with any appliance, close supervision is necessary when used by children. Do not leave children unattended: Children should not be alone or unsupervised in the area where the appliance is installed. Do not al- low them to sit or stand on the appliance.
Page 7
Unauthorized installation, maintenance, and repairs can cause considerable danger for the user. Installation, maintenance, and re- pairs must only be carried out by a Miele authorized technician. A damaged drawer can be dangerous. Always check for visible signs of damage. Never use a damaged appliance.
Page 8
Do not open the casing of the drawer under any circumstances. Any repairs not performed by a Miele authorized service techni- cian will void the warranty. Defective components should be replaced by Miele original parts only.
Page 9
IMPORTANT SAFETY INSTRUCTIONS Correct use You could burn yourself on the hot drawer or hot dishware. Pro- tect your hands with heat-resistant pot holders or gloves when han- dling hot items. Do not let them get wet or damp. Heat transfers through damp and wet material more quickly with the risk of scalding or burning yourself.
Page 10
IMPORTANT SAFETY INSTRUCTIONS Keeping Warm mode is to be used for keeping hot dishes warm, not for heating up cold food. Make sure that any food placed in the drawer is at a high enough temperature. In some foods, bacterial growth may occur if the temperature is too low.
Consult with local authorities, dealers or Miele in order to dispose of and recycle electrical and electronic appliances. Miele assumes no responsibility for deleting any personal data left on the appliance being disposed.
Overview ESW 7010, ESW 7110 a Non-slip liner b Controls and indicators c Drawer front with Push2open mechanism The drawer can be opened and closed by lightly pressing the drawer front.
Overview ESW 7570, ESW 7580, ESW 7670, ESW 7680 a Non-slip liner b Controls and indicators c Drawer front with Push2open mechanism The drawer can be opened and closed by lightly pressing the drawer front. d Wire Rack e Air vents...
Indicates that the drawer can be controlled via your mobile device. Displays/Indicator lights m Optical interface f Indicators for the selected duration (for Miele Service only) 1 h = 1 hour 2 h = 2 hours 3 h = 3 hours 4 h = 4 hours No display = Continuous operation g Segment bar indicator lights For displaying the temperature h indicator light...
Overview Included accessories The accessories supplied with your ap- pliance, as well as a range of optional ones, are available to order from Miele (see “Optional accessories”). Wire Rack For increasing the loading area (ESW 7570, ESW 7580, ESW 7670, ESW 7680).
Before first use Remove any protective foil and stick- Heating up the drawer for the ers. first time Do not remove stickers carrying Heat the empty drawer for at least safety or installation information or 2 hours. the data plate. ...
- a WiFi network fore, the availability of featured func- tions cannot be guaranteed. - the Miele app - a Miele user account You can create Miele@home availability a user account via the Miele app. The ability to use the Miele app de-...
Page 18
Before first use Connecting via the app If requested to activate the WiFi on the drawer, proceed as follows: The Miele@mobile app can be used to connect to your network. Turn the drawer off. Install the Miele@mobile app on your ...
Page 19
WPS on your router will no longer be able to access the quickly enough. Repeat the steps drawer. above. Tip: If your WiFi router does not support WPS, please connect via the Miele@mobile app.
Operation Open the drawer. Using the appliance Touch the sensor control to switch Malfunction can occur due to the drawer on. dirty and/or covered sensor buttons. Touch the Menu sensor control re- The sensor buttons do not react or peatedly until the required operating unintentional switching procedures mode lights up.
You Use pot holders when removing the can operate your drawer remotely with dishware. the Miele@mobile app. Operation via the sensor buttons has Duration precedence over operation via the app.
Operation Temperature settings Each operating mode has its own temperature range. The factory default recom- mended temperatures are printed in bold. The temperature can be altered in 10°F (5°C) increments by touching the Temperature sensor control. The last temperature selected is automatically activated the next time the drawer is switched on, and this is shown in the control field (exception: Low temperature cooking).
Keeping food warm Tips To maintain your food’s optimum quality please note the following: - Place the hot food in pre-heated dishware. Place the dishware in the drawer while it is being pre-heated. - Do not cover roast or fried food which you want to keep crisp.
Page 24
Keeping food warm Health risk caused by using too low a temperature. Bacteria may develop in the food if the temperature used for keeping food warm is too low. Only use the Keeping food warm operating mode. This operating mode is for keeping food warm which has just been cooked and is still hot.
- how the load is arranged An additional wire rack is available to - temperature setting order via the Miele online shop, Miele Customer Service, or from your Miele dealer (see “Optional accessories”).
Pre-heat the drawer with the suitable cooking containers for 15 minutes. This If food probes from other Miele Built- ensures that the dishware and the inte- in Appliances are used in the drawer, rior of the drawer reach the required they may affect the built-in appli- temperature.
Page 30
Low temperature cooking Using the Low temperature Tips cooking operating mode - Do not cook the food all the way through. Sear the food again after Select the Low temperature cook- cooking. ing operating mode. - The food can be sliced straight away. ...
Page 31
Low temperature cooking Pre-heat the cooking container for 15 minutes. In this time, rest the food at room temperature. Place the food into the pre-heated cooking container in the compartment. The cooking durations given in the charts are guidelines only. The food can be cooked further if required.
Page 32
Low temperature cooking Pork cooking chart [min] * °F [°C] [min] Type of meat Tenderloin 6–8 total 145 (60) 90–110 approx. 19 1/2 lb (550 g) Medallions 2 per side 145 (60) 85–100 approx. 1 1/2"...
Page 33
Low temperature cooking Fish cooking chart [min] °F [°C] [min] Type of fish Salmon 2 on the 126 (52) 45–60 0.8 lb (400 g) skin side Trout (whole) 2 per side 126 (52) 15–30 approx. 3/4 lb (350 g)
Networking is carried out via the Miele@mobile app as normal. See “Before using for the first time – Setting up Miele@home” as well as the Miele@mobile app for detailed informa- tion about this function. Operation via the sensor buttons has precedence over operation via the app.
Sabbath mode Activating Sabbath mode To comply with religious requirements, the drawer can be programmed for the Duration of 24 hours duration of the Sabbath. This mode will be switched off automatically after If necessary, switch the drawer off. about 24 or 72 hours, depending on ...
Cleaning and care Risk of damage due to moisture Danger of burning from hot inte- ingress. rior. The steam from a steam cleaner The interior of the drawer will be hot could reach live electrical compo- after use. nents and cause a short circuit.
Page 38
Cleaning and care Cleaning the drawer front and Cleaning the non-slip liner interior Damage due to incorrect clean- ing. Malfunction can occur due to Washing the non-slip liner in a dish- dirty and/or covered sensor buttons. washer or washing machine will The sensor buttons do not react or damage it.
You can save time and money in many cases, as you do not need to contact Miele Customer Service. Information to help you rectify faults yourself can be found at www.miele.com/ser- vice. The following tables are designed to help you to find the cause of a malfunction or a fault and to resolve it.
Page 40
Frequently asked questions Problem Possible cause and solution The Warm Dishes/Plates operating mode was not The dishware is not hot enough. selected. Set the correct operating mode. The temperature setting is too low. Select a higher temperature. The air vents are covered. ...
Optional accessories Miele offers a range of useful acces- Wire Rack sories, as well as cleaning and condi- tioning products for your appliance. These products can be easily ordered from the Miele webshop or your Miele dealer. For increasing the loading area (ESW 7570, ESW 7580, ESW 7670, ESW 7680).
Customer Service Information to help you rectify faults yourself and about Miele spare parts can be found at www.miele.com/service. Contact in the event of a fault In the event of a fault which you cannot remedy yourself, please contact your Miele dealer or Miele Customer Service.
Miele as being suitable. Miele cannot guarantee trouble-free operation if the appliance is operated in combination with appliances other than those quoted by Miele as being suitable. The base on which the drawer and the combination appliance are fitted must be fixed in place and must support the weight of both ap- pliances.
*INSTALLATION* Installation Installation notes The drawer is available in 3 models, which differ in height. The building-in dimen- sions for the drawer must be added to the building-in dimensions for the combina- tion appliance to establish the niche size required. Combination options ESW 7010 ESW 7110 ESW 7570...
Installation Installation dimensions ESW 7010, ESW 7110 Combination with an H 2840 or CVA/DGC/H 7x4x Miele Drawers can be installed flush or proud. Discuss your requirements with your architect, kitchen designer, and installer. More installation drawings are available on the Miele website.
*INSTALLATION* Installation Combination with a DGC/H 7x6x Miele Drawers can be installed flush or proud. Discuss your requirements with your architect, kitchen designer, and installer. More installation drawings are available on the Miele website. The housing unit must not have a back panel installed behind the built-in niche.
*INSTALLATION* Installation Connections and ventilation A Cutout (min. 28 sq in/ 18,000 mm²) for power cord, water hoses, and ventilation ! No electrical connection in this area. The socket for the electrical connection must be accessible, e.g., in an adjacent kitchen cabinet. E Electrical connection...
Installation dimensions ESW 7570, ESW 7670 Combination with a CVA/DGC 7x7x or H 7x7x BM Miele Drawers can be installed flush or proud. Discuss your requirements with your architect, kitchen designer, and installer. More installation drawings are available on the Miele website.
*INSTALLATION* Installation Combination with a DGC 7x8x Miele Drawers can be installed flush or proud. Discuss your requirements with your architect, kitchen designer, and installer. More installation drawings are available on the Miele website. The housing unit must not have a back panel installed behind the built-in niche.
*INSTALLATION* Installation Connections and ventilation A Cutout (min. 28 sq in/ 18,000 mm²) for power cord, water hoses, and ventilation ! No electrical connection in this area. The socket for the electrical connection must be accessible, e.g., in an adjacent kitchen cabinet. E Electrical connection...
Installation dimensions ESW 7580, ESW 7680 Installation in a tall or base cabinet Miele Drawers can be installed flush or proud. Discuss your requirements with your architect, kitchen designer, and installer. More installation drawings are available on the Miele website.
*INSTALLATION* Installation Connections and ventilation A Cutout (min. 28 sq in/ 18,000 mm²) for power cord, water hoses, and ventilation ! No electrical connection in this area. The socket for the electrical connection must be accessible, e.g., in an adjacent kitchen cabinet. E Electrical connection...
*INSTALLATION* Installation Installation Check that the base on which the drawer will sit is clean and level (use a level). This is important for the ap- pliance to function correctly. Push the drawer into the housing unit until the drawer front is flush with the housing unit and make sure that it is correctly aligned in the unit.
Instal- lation, repair, and maintenance work should only be performed by a Miele-authorized service technician. The voltage and frequency listed on the rating label must correspond with the household electrical supply to prevent appliance damage.
Declaration of conformity Compliance Statement Radio Module This device complies with Part 15 of the This device contains the following WiFi FCC Rules and contains licence-ex- module: empt transmitter(s)/receiver(s) that com- FCC ID 2ACUWEK037 ply with Innovation, Science and Eco- nomic Development Canada’s licence- IC ID 5669C-EK37...
Page 59
Customer Service. U.S.A. Canada Miele, Inc. Importer Miele Limited National Headquarters 9 Independence Way Headquarters and Miele Centre Princeton, NJ 08540 161 Four Valley Drive www.mieleusa.com Vaughan, ON L4K 4V8 www.miele.ca Customer Support Phone: 888-99-MIELE (64353) Customer Care Centre info@mieleusa.com...