Table of Contents
Advertisement
Quick Links
SE 30/125 S IP
Ignition Protected
SIDE-POWER
thruster assembly
Thruster Systems
Installation and user manual
2175 NW 34th Ave Miami, FL 33142 USA
Phone: 786-621-3010 • Fax: 786-621-3046
Website: https://yachtaidmarine.com/product-category/marine-bow-thrusters/
Email: info@yachtaidmarine.com
https://yachtaidmarine.com/product-category/marine-bow-thrusters/
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Side-Power SE 30/125 S IP
Summary of Contents for Side-Power SE 30/125 S IP
- Page 1 SE 30/125 S IP Ignition Protected SIDE-POWER thruster assembly Thruster Systems Installation and user manual 2175 NW 34th Ave Miami, FL 33142 USA Phone: 786-621-3010 • Fax: 786-621-3046 Website: https://yachtaidmarine.com/product-category/marine-bow-thrusters/ Email: info@yachtaidmarine.com https://yachtaidmarine.com/product-category/marine-bow-thrusters/...
-
Page 2: Table Of Contents
Integrated microprocessor monitors solenoids, reducing wear and risk of solenoid lock-in. Auto-stop of thruster in case of accidental solenoid lock-in or if run signal is continous for more than 3 minutes. SE 30/125 S IP Responsible installer must consider and facilitating Thrust at 10.5V/ 21V*... -
Page 3: Planning & Important Precautions
Planning and important precautions Prior to installation, it is important that the installer reads this guide to ensure necessary acquaintance with this product. The electromotor assembly must be handled carefully. Do not put it down on the driveshaft. Beware to keep installation within advised measurements. We advice to paint the gearhouse and propellers with antifouling. -
Page 4: Bolt On Installation
If this is not so, then the area on the transom will have to be If you are installing the standard Side-Power dual joystick flattened to ensure a snug fit. panel this is already secured. -
Page 5: Gearhouse And Motorbracket
Fig. 1 Fig. 2 Bolt tightening forces: Bolts (2x) holding gearhouse to bracket: 17 Nm (12,4 lb/ft) Designed by Material Type Date Drawing nr Tolerance NS-ISO 2768-1 R. Hansen SM-101539 13.09.2011 Copyright All rights reserved Title SL E IP N E R M O T O R A S Part nr Weight Size... - Page 6 Fig. 1 Thread glue Fitting propellers 1. Push the propeller on to the shaft and turn until the internal spline in the propeller hub aligns with the external spline on the propeller shaft. 2. Push the propeller onto the shaft with the track for the drivepin in an horizontal position (same direction as you set the drivepin), all the way in.
-
Page 7: Electromotor Ip Assembly
Fig. 2 Fig. 1 Designed by Material Type Date Drawing nr Tolerance NS-ISO 2768-1 R. Hansen 13.09.2011 SM-101539 Designed by Material Type Date Drawing nr Tolera R. Hansen SM-101539 13.09.2011 Copyright All rights reserved Title Copyright All rights reserved Title SL E IP N E R M O T O R A S SLE IPN E R M O TO R A S Part nr... -
Page 8: Electrical Installation
RED: Battery Designed by Material Type Date Drawing nr Tolerance NS-ISO 2768-1 R. Hansen SM-101462 30.08.2011 Copyright All rights reserved Title Battery & cable recommendations: SL E IP N E R M O T O R A S Model Voltage Nominal Min. -
Page 9: Control Panel And Control-Leads
Pin configuration in contacts SIDEPOWER SIDEPOWER THRUSTER THRUSTER Connect round end SLEIPNER SLEIPNER of control adapter cable to the round socket on IP casing Control panel and control-leads Control panel and control-leads • You can install as many panels as you wish by using optional Y-connectors. If two or more panels are operated at the same time in •... -
Page 10: "Visual" Wiring Diagram
"Visual" wiring diagram "Visual" wiring diagram SE 30/125S ignition protected thruster assembly SP55S2i ignition protected thruster assembly 1.1 - 2006 version 1.5 - 2015 https://yachtaidmarine.com/product-category/marine-bow-thrusters/... -
Page 11: Technical Wiring Diagram
Technical wiring diagram Round connector 4 pin on motor Motor housing connector Fused blue 9 red (+) inside 1A (sig -) blue (sig +) Electronic interface box 6 1232i white black (-) grey (sig +) grey (sig -) black brown Battery Fuse main... -
Page 12: Checklist
Checklist Propeller is fastened correctly to the shaft. Propeller turns freely in tunnel. The anode holding screw is tightened well with thread glue. All electrical wiring, cable sizes and battery capacity is according to the thruster installation manual. ... -
Page 13: Important User Precautions
Important user precautions • Ensure that you know the location of the main battery switch that disconnects the thruster from all power sources (batteries) so that the thruster can be turned off in case of a malfunction. • Always turn the main power switch off before touching any part of the thruster, as an incidental start while touching moving parts can cause serious injuries. -
Page 14: How To Use Sidepower Thrusters
2. Please take some time to exercise thruster usage in open water to avoid damages to your boat. 3. Turn the controlpanel on by pushing both "ON" buttons on the original Side-Power panel simultaneously. If another type of control is 3. -
Page 15: Maintenance
Electromotor assembly Composite 5-blade propeller for ultimate performance. Pre-filled lifetime lubricated gearhouse. Changeable anode protects gearhouse from corrosion in seawater. Thread glue Fastening screw for anode Anode Propeller lock nut Washer Drivepin for propeller Maintenance » Keep the propeller and gearhouse clean from growth by painting with antifouling before every season. PS ! The anode, sealing and propeller shafts must absolutely not be painted. -
Page 16: Troubleshooting
Troubleshooting Before seeking assistance at the help desk of your Sidepower dealer / distributor please perform these tests and make notes of all measurements to ensure that they have as much information as possible to work on. NB! All check points and solutions must be carried out after consulting the relevant information elsewhere in this manual to under- stand how the system is intended to work. -
Page 17: Warranty Statement
Warranty statement 1. The equipment manufactured by Sleipner Motor AS (The “Warrantor”) is warranted to be free from defects in workmanship and materials under normal use and service. 2. This Warranty is in effect for of two years (Leisure Use) or one year (Commercial use) from the date of purchase by the user. Proof of purchase must be included, to establish that it is inside the warranty period. -
Page 18: Parts List
SP 30 S2i PARTS LIST - SE 30/125 S SP 30 S2i / SP 40 S2 i/ SP 55 S2i 3.7 - 2006 SE 30/125S ignition protected thruster assembly SE 30/125S ignition protected thruster assembly 1.0 - 2007 version 1.5 - 2015 https://yachtaidmarine.com/product-category/marine-bow-thrusters/... - Page 19 SE 30/125S ignition protected thruster assembly version 1.5 - 2015 https://yachtaidmarine.com/product-category/marine-bow-thrusters/...
- Page 20 Worldwide sales and service 2175 NW 34th Ave Miami, FL 33142 USA Phone: 786-621-3010 • Fax: 786-621-3046 Website: https://yachtaidmarine.com/product-category/marine-bow-thrusters/ Email: info@yachtaidmarine.com https://yachtaidmarine.com/product-category/marine-bow-thrusters/...
Need help?
Do you have a question about the SE 30/125 S IP and is the answer not in the manual?
Questions and answers