Monoprice Voxel 33820 User Manual page 5

• Do not subject the product to extreme force, shock, or fluctuations in temperature
or humidity.
• This device is intended for indoor use only.
• Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately unplug it from the power outlet and allow it to fully dry
before reapplying power.
• Do not touch the device, the power cord, or any other connected cables with wet
hands.
• Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
• Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
• Unplug this device from the power source when not in use.
• Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
• Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
• Use only in a well-ventilated area. Do not use in close, confined spaces.
• Take care when using the scraper to remove a model. Never direct the scraper
towards your fingers or body.
• The printer is designed to operate with an ambient temperature ranging from +59°F
(+15°C) to +86°F (+30°C), with a relative humidity from 20-70%. Printing outside
these limits may result in low quality prints.
• Use eye protection when cleaning or sanding the printed models to avoid getting
small particles in your eyes.
5