Installing The Expansion Card; Removing The Wireless Local Area Network (Wlan) Card - Dell OptiPlex XE2 Small Form Factor Owner's Manual

Installing the expansion card

1. Insert the expansion card into it's connector on the system board and press down until it is securely in place.
NOTE: If your computer has a powered expansion connect the power cable to the card.
2. Rotate the release tab on the card-retention latch downward.
3. Install the cover.
4. Follow the procedure in

Removing the Wireless Local Area Network (WLAN) Card

1. Follow the procedure in
2. Remove the cover.
3. Remove the screws that secure the antenna puck to the computer.
4. Pull the antenna puck from the computer.
5. Press the blue tab and lift the latch outwards. Lift and remove the WLAN card from the connector on the system
board.
14
After working inside your computer.
Before working inside your computer.