Dell OptiPlex XE Mounting Manual

Mounting your dell™ optiplex™ xe using a wall-mount unit

Hide thumbs Also See for OptiPlex XE:

Download this manual See also: Service Manual, Installation Manual

About Warnings

WARNING:

or death.

Mounting Your Dell™ OptiPlex™ XE Using

a Wall-Mount Unit

WARNING:

shipped with your computer. For additional safety best practices information, see the

Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTE:

The size of the wall-mount unit differs based on the computer's form factor.

1 If you are mounting a computer with the optional Ingress Protection 51 (IP51)

kit attached, remove the paddings from the wall-mount unit.

February 2010

A WARNING indicates a potential for property damage, personal injury,

Before working inside your computer, read the safety information that

Page 1 About Warnings WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Mounting Your Dell™ OptiPlex™ XE Using a Wall-Mount Unit WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Page 2 2 Mount the wall-mount unit to the wall using the screws that shipped with the unit.
Page 3 3 Place the computer into the wall-mount unit. Without the IP51 kit With the IP51 kit...
Page 4 Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and OptiPlex are trademarks of Dell Inc.