Table of Contents
Advertisement
11.7
Checking the static sag of the shock absorber
11.8
Checking the riding sag of the shock absorber
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Measure dimension
–
Hold the motorcycle upright with aid of an assistant.
–
Measure the distance again between the rear axle and mark-
ing SAG on the rear fender using the sag gage.
–
Note the value as dimension
Info
The static sag is the difference between measure-
ments
–
Check the static sag.
Static sag
»
If the static sag is less or more than the specified value:
–
Adjust the spring preload of the shock absorber.
(
p. 50)
402416-10
–
Measure dimension
–
With another person holding the motorcycle, the rider, wear-
ing full protective clothing, sits on the seat in a normal sitting
position (feet on footrests) and bounces up and down a few
times.
The rear wheel suspension levels out.
–
Another person again measures the distance between the
rear axle and marking SAG on the rear fender using the sag
gage.
–
Note the value as dimension
Info
The riding sag is the difference between measure-
ments
–
Check riding sag.
Riding sag
»
If the riding sag differs from the specified measurement:
402417-10
–
Adjust the riding sag.
TUNING THE CHASSIS 11
A
of rear wheel unloaded. (
B
.
A
B
and
.
37 mm (1.46 in)
A
of rear wheel unloaded. (
C
.
A
C
and
.
110 mm (4.33 in)
(
p. 51)
p. 55)
p. 48)
p. 48)
49
Advertisement
Table of Contents
