SCHUNK iTENDO2 easy monitor Assembly And Operating Manual page 39

Possible malfunction /
occurring errors
Alarm is not being issued
correctly
01.00 | iTENDO² easy monitor | Assembly and Operating Manual | en | 1547510
Possible causes
Output is only being switched
for 5 seconds
Parameters of the alarm limits
are not correct
Components are indicating a
fault
Troubleshooting
Remedial measures
Observe alarm times. See
ePlan in the appendix.
TIP: To trigger a permanent
signal, the customer can use
self-locking functions or
circuits.
Check the values of the
process-specific alarm
limits: } 5.6.3.7 [/ 36]
Check the outputs on the
iTENDO² Connect Box and
cable connections. See the
Assembly and Operating
Manual for iTENDO² easy
connect (1539948).
39