Output Channel Mode (Prog > Out1-Out6 > Mode) - Omega CN8EPt User Manual

TM
PLATINUM Series Controllers User's Guide
7.4.1 Output Channel Mode (PRoG > oUt1–oUt6 > ModE)
Select Output Channel Mode (ModE) to configure the specified output.
Navigate to the desired setting. Settings include the following:

oFF

PId

oN.oF – Set the output to On/Off Control Mode

ALM.1 – Set the output to be an Alarm using the ALM.1 configuration

ALM.2 – Set the output to be an Alarm using the ALM.2 configuration

RtRN – Set up the output for Retransmission

RE.oN – Turn on the output during Ramp events

SE.oN – Turn on the output during Soak events
Select the indicated setting.
Turn off this output (oFF).
Select PID Control Mode (PId) for this output (factory default). PID parameters are
set outside the specific output submenus, as more than one output can be used for
PID control at a time. See
Select PID Control Mode (PId.2) for this output. PID.2 parameters are set outside
the specific output submenus, as more than one output can be used for PID.2
control at a time. See
Select On/Off Control Mode (oN.oF) for this output. More than one output can be
set up for oN.oF control. For Heat / Cool control set the output connected to the
heater with ACtN equal to RVRS and the output connected to the cooling device
with ACtN set to dRCt.
M5451
– Turn off the output channel (factory default)
– Set the output to Proportional-Integral-Derivative (PID) Control Mode
7.4.1.1 Turn Off Output Channel (PRoG > oUt1–oUt6 >
ModE > oFF)
7.4.1.2 PID Control Mode (PRoG > oUt1–oUt6 > ModE >
PId)
7.5 PID Configuration (PRoG >
7.4.1.3 PID 2 Control Mode (PRoG > oUt1–oUt6 > ModE
> PId.2)
7.5 PID Configuration (PRoG >
7.4.1.4 On/Off Control Mode (PRoG > oUt1–oUt6 >
ModE > oN.oF)
Reference Section: Programming Mode (PRoG)
PID).
PID).
Omega Engineering | www.omega.com
54