Omega CN8EPt User Manual page 23

TM
PLATINUM Series Controllers User's Guide
Level Level Level
2 3 4
AMbR
GRN
dEFt
HI.HI oFF
oN
LtCH No
yES
botH
RMt
CtCL N.o.
N.C.
A.P.oN yES
No
dE.oN ____
dE.oF ____
ALM.2
oUt1
Note: This submenu is the same for all other outputs.
ModE oFF
PId
PId.2
oN.oF
ALM.1
ALM.2
RtRN
M5451
Level Level
5 6
Amber display when Alarm is active
Green display when Alarm is active
Color does not change for Alarm
High High / Low Low Alarm Mode turned off
____ Offset value for active High High / Low Low Mode
Alarm does not latch
Alarm latches until cleared via front panel
Alarm latches, cleared via front panel or digital input
Alarm latches until cleared via digital input
Output activated with Alarm
Output deactivated with Alarm
Alarm active at power on
Alarm inactive at power on
Delay turning off Alarm (sec), default = 1.0
Delay turning off Alarm (sec), default = 0.0
Alarm 2
oUt1 is replaced by output type
Output does nothing
PID Control Mode
ACtN RVRS Reverse acting control (heating)
dRCt Direct acting control (cooling)
RV.DR Reverse/Direct acting control (heating/cooling)
PID 2 Control Mode
ACtN RVRS Reverse acting control (heating)
dRCt Direct acting control (cooling)
RV.DR Reverse/Direct acting control (heating/cooling)
ACtN RVRS Off when > SP1, on when < SP1
dRCt Off when < SP1, on when > SP1
dEAd ____ Deadband value, default = 5
S.PNt SP1 Either Setpoint can be used of on/off, default is SP1
SP2 Specifying SP2 allows two outputs to be set for heat/cool
Output is an Alarm using ALM.1 configuration
Output is an Alarm using ALM.2 configuration
Rd1 ____ Process value for oUt1
oUt1 ____ Output value for Rd1
Rd2 ____ Process value for oUt2
oUt2 ____ Output value for Rd2
Complete Menu Structure
Notes
Omega Engineering | www.omega.com
23