Omega CN8EPt User Manual page 24

TM
PLATINUM Series Controllers User's Guide
Level Level Level
2 3 4
RE.oN
SE.oN
SEN.E
OPL.E
CyCL ____
RNGE 0-10
0-5
0-20
4-20
0-24
oUt2
oUt3
PId ACtN RVRS
dRCt
RV.DR
A.to ____
tUNE StRt
GAIN _P_
_I_
_d_
rCg ____
oFst ____
dEAd ____
%Lo ____
%HI ____
AdPt ENbL
dSbL
PId.2 Note: This menu is the same for PID menu.
RM.SP oFF
oN 4–20
0–24
0–10
0–1
M5451
Level Level
5 6
Activate during Ramp events
Activate during Soak events
Activate if any sensor error is detected
Activate if any output is open loop
PWM pulse width in seconds
Analog Output Range: 0–10 Volts
0–5 Volts
0–20 mA
4–20 mA
0–24 mA
oUt2 is replaced by output type
oUt3 is replaced by output type (1/8 DIN can have up to 6)
Increase to SP1 (i.e., heating)
Decrease to SP1 (i.e., cooling)
Increase or Decrease to SP1 (i.e., heating/cooling)
Set timeout time for autotune
Initiates autotune after StRt confirmation
____ Manual Proportional Band setting
____ Manual Integral Factor setting
____ Manual Derivative Factor setting
Relative Cool Gain (heating/cooling mode)
Control Offset
Control Dead band/Overlap band (in process unit)
Low clamping limit for Pulse, Analog Outputs
High clamping limit for Pulse, Analog Outputs
Enable fuzzy logic adaptive tuning
Disable fuzzy logic adaptive tuning
Use SP1, not remote Setpoint
Remote analog Input sets SP1; range: 4–20 mA
Note: This submenu is the same for all RM.SP ranges.
RS.Lo ____ Min Setpoint for scaled range
IN.Lo ____ Input value for RS.Lo
RS.HI ____ Max Setpoint for scaled range
IN.HI ____ Input value for RS.HI
0–24 mA
0–10 V
0–1 V
Complete Menu Structure
Notes
Omega Engineering | www.omega.com
24