Connection To The Pu Connector - Mitsubishi FR-E500 Series Instruction Manual

2.2.5 Connection to the PU connector

(1) When connecting the parameter unit using a cable
Use the option FR-CB2# or the following connector and commercially available cable:
<Connection cable>
! Connector : RJ45 connector
Exampl: 5-554720-3, Tyco Electronics Corporation
! Cable
: Cable conforming to EIA568 (e.g. 10BASE-T cable)
Example: SGLPEV 0.5mm×4P (Twisted pair cable, 4 pairs),
MITSUBISHI CABLE INDUSTRIES, LTD.
<Maximum wiring length>
! Parameter unit (FR-PU04): 20m
(2) For RS-485 communication
With the accessory cover disconnected, the PU
connector can be
operation from a personal computer etc.
When the PU connector is connected with a
personal, FA or
communication cable, a user program allows the
inverter to be run and monitored and the parameter
values to be read and written.
<PU connector pin-outs>
Viewed from the inverter (receptacle side) front
Note: 1. Do not connect the PU connector to a computer's LAN board, FAX modem
socket or telephone modular connector. Otherwise, the product may be
damaged due to electrical specification differences.
2. Pins 2) and 8) (P5S) provide power to the parameter unit. Do not use these
pins for RS-485 communication.
used for communication
other computer
26
Get other manuals https://www.bkmanuals.com
INSTALLATION AND WIRING
8) to 1)
by a
1) SG 5) SDA
2) P5S 6) RDB
3) RDA 7) SG
4) SDB 8) P5S
2