Furuno SC-50 Operator's Manual page 41

3. OPERATION
5. Choose SENTENCE and then press the [ENT] key.
6. Use the Omnipad to choose the sentence to process and then press the
[ENT] key.
HDT: True heading (required for radar, AIS, ECDIS, etc.)
HDM: Magnetic heading (Some boaters may want magnetic heading when
ROT: Rate-of-turn data
ATT:
VDR: Set and drift
VTG: Course over ground and ground speed
GGA: Global positioning system (GPS) fix data
GNS: GNSS fix data
GLL:
VHW: Water speed and heading
VBW: Dual ground/water speed
HVE: Pitch and roll data (FURUNO's proprietary sentence)
ZDA
7. Use the Omnipad to choose OFF or ON as appropriate and then press the
[ENT] key. Sentences selected for output are marked with an asterisk.
8. Choose item desired and then press the [ENT] key.
9. Choose ON or OFF as appropriate and then press the [ENT] key.
10. Press the [MENU] key to return to the DATA OUT1 menu.
11. Choose BAUD RATE and then press the [ENT] key.
3-10
HDT
HDM
ROT
ATT
VDR
DATA OUT1 menu, sentences
the boat is fitted with only a magnetic compass without correction of
deviation and variation. HDM is obtained in this equipment by adding
the magnetic variation to HDT automatically.)
True heading, pitching, rolling (FURUNO's proprietary sentence)
Geographic position, latitude/longitude
Time and date
Baud rate options
Get other manuals https://www.bkmanuals.com
DATA OUT1
VTG VHW
GGA VBW
GNS HVE
GLL ZDA
OFF
ON
4800BPS
9600BPS
19200BPS
38400BPS