The Java Client Ap Connection Screen - ATEN RCM Series User Manual

KVM over IP User Manual

The Java Client AP Connection Screen

A description of the Connection Screen is given in the following table:
Item
Server List
Server
Message Panel
Switch to Remote View Once you have been authenticated (see Connecting –
46
Each time the JavaClient.jar file is run, it searches the User's
local LAN segment for RCM Series of KVM Over IP Switches,
and lists whichever ones it finds in this box. If you want to
connect to one of these units, double-click it. (See
Connecting – Windows Client AP, page 43 for details.)
Note: 1. The switch will not appear in the list unless its
Enable Device List configuration parameter has
been enabled. See Operating Mode, page 161 for
details.
2. Only units whose Access Port settings for Program
(see Service Ports, page 165) match the number
specified for Port in the Server area of this dialog
box appear in the Server List window.
This area is used when you want to connect to a RCM Series
of KVM Over IP Switch at a remote location. You can drop
down the IP list box and select an address from the list. If the
address you want isn't listed, you can key in the target IP
address in the IP field, and its port number in the Port field. (If
you don't know the port number, contact your Administrator.)

When the IP address and Port number have been
specified, click Connect. (See Connecting – Windows
Client AP, page 43 for details.)

When you have finished with your session and come back
to this dialog box, click Disconnect to end the connection.
Located just to the right of the Server panel, the Message
panel lists status messages regarding the connection to the
RCM Series of KVM Over IP Switch.
Windows Client AP, page 43 for details), this button becomes
active. Click it to switch to the GUI Main Page. The GUI Main
Page is described on page 52.
Description