Cc Management Settings - ATEN RCM Series User Manual

KVM over IP User Manual
Item
Admin Name
Password
Search DN
Timeout
On the LDAP / LDAPS server, Users can be authenticated with any of the
following methods:
 With MS Active Directory schema.
 Without schema – Only the Usernames used on the RCM Series of KVM
Over IP Switch are matched to the names on the LDAP / LDAPS server.
User privileges are the same as the ones configured on the switch.
 Without schema – Only Groups in AD are matched. User privileges are the
ones configured for the groups he belongs to on the switch.
 Without schema – Usernames and Groups in AD are matched. User
privileges are the ones configured for the User and the Groups he belongs
to on the switch.
Note: 1. LDAP attribute is required for complete setup. LDAP
attribute can be retrieved from the GET command using the
Terminal interface. Please refer to Terminal on page 210 for
more details. An unique X500 Object ID (OID) is assigned
from your organization or defined by you own (e.g.
1.3.6.1.4.1.21317.1.3.1.3) for the attribute.
2. For more information on configuring LDAP, you can
download the full LDAP instructional manual from our
website.

CC Management Settings

To allow authorization for the RCM Series of KVM Over IP Switch through a
CC (Control Center) server, check Enable and fill in the CC Server's IP address
and Service port in the appropriate fields. You can use the IPv4 address, the
IPv6 address or the domain name in the CC Server IP field.
174
Key in the LDAP administrator's username.
Key in the LDAP administrator's password.
Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Set the time in seconds that the RCM Series of KVM Over IP
Switch waits for an LDAP or LDAPS server reply before it times
out.
Action