Siemens LITHOSTAR Multiline Manual page 64

64
Fig. 31: D7 board
Fig. 33: Potentiometer r4
•
Move the O drive to the mechanical end stop, passing the 30° position, in unregulated
mode so that the rubber end stops are against the mechanical end stop
((Fig. 34 / p.
•
Switch the system off.
•
Unplug the motor connector
•
Remove board D7
•
Loosen the screws for the D7 board holder
((5/Fig. 32 / p.
•
Loosen the screw
•
Lift up the energy chain guide and secure it above
LITHOSTAR Multiline
64)).
((A/Fig. 32 / p.
((2/Fig. 31 / p.
64)).
((4/Fig. 31 / p.
RXL2-120.841.02.01.02
09.05
Working on the Orbital Drive
Fig. 32: Board D7_tilted
Fig. 34: Rubber end stop
64)).
64)).
((3/Fig. 31 / p.
64)) at the energy chain guide.
((6/Fig. 32 / p.
Page 64 of 72
CS PS 24
64)) and tilt it forward
64)).
Siemens AG
Medical Solutions