Cooling System Strainers - Mercury Racing 500R Operation And Maintenance Manual

REPLACING THE TRIM THRUST GUIDE WEAR PADS
IMPORTANT: When replacing the trim thrust guide wear pads, replace both
pads and install new retaining hardware.
a a
c
a - M6 x 20 screw with patch lock pad (8 quantity, 4 on each trim wear
pad)
b - Trim thrust guide wear pad (2 quantity)
c - Trim manifold
Description
M6 x 20 screw (8)

Cooling System Strainers

IMPORTANT: Lower cowl removal is necessary to access the strainers.
Refer to the appropriate service manual section for lower cowl removal and
installation procedures.
SUPPLY HOSE STRAINER
IMPORTANT: The two cooling hoses attached to the strainer housing can
remain attached during disassembly and cleaning.
1. Remove the two M6 x 16 screws securing the elbow to the strainer
housing.
MAINTENANCE
a a
Nm
112
lb‑in.
6 53
b
74679
lb‑ft
–
eng