Spare Parts; Return; Disposal - Endress+Hauser Liquiphant FTL63 Density Operating Instructions Manual

Vibronic density measurement for liquids specifically for the food and life sciences industries

Hide thumbs Also See for Liquiphant FTL63 Density:

Table of Contents

Liquiphant FTL63 Density

Endress+Hauser

12.2

Spare parts

• Some replaceable device components are identified by a spare part nameplate. This

contains information about the spare part.

• All the spare parts for the measuring device, along with the order code, are listed in the

W@M Device Viewer (www.endress.com/deviceviewer) and can be ordered. If available,

users can also download the associated Installation Instructions.

Device serial number or QR code:

Located on the device and spare part nameplate.

12.3

The requirements for safe device return can vary depending on the device type and

national legislation.

1. Refer to the web page for information:

http://www.endress.com/support/return-material

 Select the region.

2. Return the device if repairs or a factory calibration are required, or if the wrong

device was ordered or delivered.

12.4

If required by the Directive 2012/19/EU on waste electrical and electronic equipment

(WEEE), the product is marked with the depicted symbol in order to minimize the

disposal of WEEE as unsorted municipal waste. Do not dispose of products bearing this

marking as unsorted municipal waste. Instead, return them to the manufacturer for

disposal under the applicable conditions.

Repair

Table of Contents