Intended Use; Incorrect Use; Workplace Safety; Operational Safety - Endress+Hauser Liquiphant FTL63 Density Operating Instructions Manual

Liquiphant FTL63 Density
Endress+Hauser
‣
Must have read and understood the instructions in the manual and supplementary
documentation
‣
Follow instructions and comply with conditions
2.2

Intended use

• Use the device only for measuring the density of liquids.
• Improper use can pose hazards
• Ensure that the device is free of defects while it is in operation
• Use the device only for media to which the wetted materials have an adequate level of
resistance
• Do not exceed or drop below the relevant limit values for the device
For more details, see the "Technical data" section
A
See the Technical Documentation
2.2.1

Incorrect use

The manufacturer is not liable for damage caused by improper or non-intended use.
Residual risks
Due to heat transfer from the process, the temperature of the electronics housing and the
assemblies contained therein may rise to 80 °C (176 °F) during operation.
Danger of burns from contact with surfaces!
‣
If necessary, ensure protection against contact to prevent burns.
2.3

Workplace safety

For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4

Operational safety

Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for ensuring the interference-free operation of the device.
Modifications to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers.
‣
If, despite this, modifications are required, consult with Endress+Hauser.
Repair
To ensure continued operational safety and reliability:
‣
Only perform repair work on the device if this is expressly permitted.
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use original spare parts and accessories from Endress+Hauser only.
Hazardous area
To eliminate danger to persons or the facility when the device is used in the hazardous
area (e.g. explosion protection):
‣
Check the nameplate to verify whether the ordered device can be used for the intended
purpose in the hazardous area.
Basic safety instructions
7