Table of Contents
Advertisement
Conventional Cruise Control
■ Resuming a vehicle speed that was previously stored
A vehicle speed that has been previously set is stored in memory
vehicle speed, press the RES/SET switch to the "RES/+". (The EyeSight display area shows
the set condition again.)
Resume is possible when a vehicle speed was previously set, and the current vehicle speed
is approximately 20 MPH (30 km/h) or more.
* The vehicle speed stored in memory is erased at the following times:
- The cruise control is turned off by pressing the
- Either vehicle Dynamics Control or Traction Control Function has been
activated.
- The cruise control mode was switched from Conventional Cruise Control
to Adaptive Cruise Control.
The vehicle will drive at a constant speed that was set between approxi-
mately 25 MPH (40 km/h) and 90 MPH (145 km/h).
If there is no vehicle speed in the memory (a previously set vehicle speed),
the vehicle speed cannot be resumed by depressing the RES/+ switch.
84
S01993
NOTE
*
. To recall and set that
(CRUISE) switch.
S02328
Advertisement
Table of Contents
