Subaru LEGACY OUTBACK 2017 Owner's Manual page 41

Adaptive Cruise Control
How to use Adaptive Cruise Control
Adaptive Cruise Control is available when the engine is turned on.
■ Setting Adaptive Cruise Control
(1) Setting Adaptive Cruise Control to standby status
Press the (CRUISE) switch. At this time, "
cle indicator and the "following distance setting" are displayed on the EyeSight display area
in the multi information display.
The set vehicle speed display will read "- - MPH".
If the switch is pressed once more, the EyeSight display will turn off. It will also automatically
turn off when the engine is stopped.
To set ready status:
Adaptive Cruise Control can be set when all
of the following conditions are met and
is displayed on the EyeSight display area.
- All doors (except the rear gate/trunk) are
closed.
- The driver's seatbelt is fastened.
- The electronic parking brake is not
engaged (The brake system warning light
is turned off.).
- The select lever is in the
the paddle shift is not operated.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily stopped.
Refer to page 87.
- The road is not a steep slope.
- The steering wheel has not been turned significantly in either direction.
- X-mode is not turned on.
- The vehicle speed is between approximately 0 MPH (0 km/h) and 90 MPH (145 km/h).
38
S01985
position and
D
" (Adaptive Cruise Control), your vehi-
S01110
S01111