Subaru LEGACY OUTBACK 2017 Owner's Manual page 80

(2) Switch to Conventional Cruise Control.
Press and hold the
seconds or longer to switch from Adaptive Cruise Control to Conventional Cruise
Control. A buzzer sounds 1 short beep.
At this time, the following distance setting indicator on the EyeSight display area of the
multi information display turns off and
To set the ready status:
Conventional Cruise Control can be set when
all of the following conditions are met and
is displayed on the EyeSight display
area.
- All doors (except the rear gate/trunk) are
closed.
- The driver's seatbelt is fastened.
- The electronic parking brake is not
engaged (The brake system warning light
is turned off.).
- The select lever is in the
the paddle shift is not operated.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily stopped.
Refer to page 87.
- The road is not on a steep slope.
- The steering wheel has not been turned significantly in either direction.
- The X-mode is not turned on.
- The vehicle speed is between approximately 25 MPH (40 km/h) and 90 MPH (145
km/h).
(3) Control the accelerator pedal to reach the desired speed.
/ (following distance setting) switch for approximately 2
(Conventional Cruise Control) is displayed.
S01992
D position, and
Conventional Cruise Control
S01129
S02327
77