Subaru LEGACY OUTBACK 2017 Owner's Manual page 19

Table of Contents

Advertisement

About EyeSight
■ EyeSight temporary stop indicator (white)
This indicator illuminates when the EyeSight system is temporarily stopped.
When the ignition switch is placed in the ON position, it will illuminate if the
(CRUISE) switch or
seconds of the engine starting. It turns off when approximately 7 seconds have elapsed
since the engine started.
When it is illuminated, none of the EyeSight functions can be used except for Conven-
tional Cruise Control.
Refer to page 87.
■ Lane Departure Warning OFF indicator light
This indicator illuminates when the Lane Departure Warning and Lane Sway Warning are
off.
It also illuminates when the ignition switch is turned to the ON position, and then approxi-
mately 7 seconds after the engine starts, the Lane Departure Warning will be turned off or
remain illuminated depending on the current status (ON or OFF).
Refer to page 70.
■ Pre-Collision Braking System OFF indicator light
Illuminates when the Pre-Collision Braking System and Pre-Collision Throttle
Management are off.
It also illuminates when the ignition switch is turned to the ON position, and then turns off
approximately 7 seconds after the engine starts.
Refer to page 31.
■ Vehicle Dynamics Control OFF indicator light
It illuminates when the engine starts and turns off within approximately 2 seconds.
It illuminates when the Vehicle Dynamics Control OFF switch is pressed and Vehicle
Dynamics Control is off. Refer to the Owner's Manual for your vehicle.
■ Brake system warning light (red)
If the brake system warning light should illuminate while driving with the parking brake fully
released, turn off the Pre-Collision Braking System. Also, do not use Adaptive Cruise Con-
trol or Conventional Cruise Control.
■ Electronic parking brake indicator light
This indicator light illuminates when the electronic parking brake is applied.
Refer to the Owner's Manual for details.
■ Vehicle Dynamics Control warning light
This indicator illuminates when the engine switch is turned to the "ON" position, and turns
off approximately 2 seconds after the engine is started. It will illuminate if there is a malfunc-
tion in the VDC electrical control system.
* Refer to the Owner's Manual for details.
16
(Lane Keep Assist) switch are set to ON within approximately 7

Advertisement

Table of Contents
loading

Table of Contents