Subaru LEGACY OUTBACK 2017 Owner's Manual page 49

Adaptive Cruise Control
■ Stay-stopped function
If the vehicle in front comes to a stop while you are utilizing Adaptive Cruise Control, your
vehicle will also come to a stop and will stay stopped.
When your vehicle comes to stop after the vehicle in front has stopped, Adaptive Cruise
Control is paused and the stay-stopped function is engaged.
area is turned off and
●
Resuming Adaptive Cruise Control in stay-stopped status
Setting using the RES/SET switch
Press "SET/-" (
Press "RES/+" (
set".)
When Adaptive Cruise Control is resumed from stay-stopped status and the
vehicle in front accelerates, your vehicle will also accelerate and continue to
track the vehicle in front at the previously set following distance. However, if
the lead vehicle does not start moving or pauses, stay-stopped status will be
automatically restored after approximately 3 seconds.
Setting with the accelerator pedal
Depressing the accelerator pedal while stay-stopped is engaged cancels stay-stopped
status. At this time, Adaptive Cruise Control is resumed. The vehicle will attempt to travel
at the previously set vehicle target speed unless a lead vehicle is detected. If a lead vehi-
cle is detected, Adaptive Cruise Control will maintain the previous following distance set-
ting.
If the accelerator pedal is only slightly depressed, the stay-stopped function
may not be canceled, and the Adaptive Cruise Control may not be resumed.
46
is displayed. At the same time,
S01982
Refer to page 39 "(2) Setting Adaptive Cruise Control".)
Refer to page 51 "Returning to a vehicle speed that was previously
NOTE
NOTE
on the EyeSight display
is turned back to white.
S02325