Replacing The Batteries Of The Call-And-Park Stations/Attendant Control - Access FLOW X User Manual

Access Flow X stairli t - User Manual - Maintenance
5.3 REPLACiNG THE BATTERiES OF THE
CALL-AND-PARK STATiONS/ATTENDANT
CONTROL
The call-and-park stations use 4 AAA batteries. The li t indicates (flashes orange
when used) when the batteries need to be replaced (see chapter 6 Signals).
If the battery is low and you push one of the buttons, the status indicator flashes
orange, but the li t will continue to work. We strongly advice to change the
batteries as soon as possible. If the battery runs out even further, the status
indicator flashes red and the drive stops.
1. Remove the screw in the lower part of the wall mount, and open the battery
compartment at the backside of the call and park control station/attendant
control.
2. Replace the batteries.
3. Mount in reverse order to close the call-and-park control station (install the
screw fixation).
NOTE
A ter you have replaced the batteries, purchase new spare batteries as
soon as possible.
41