Table of Contents
Advertisement
Adjusting the plant guard:
Starting the trimmer:
p
Lengthening of the filament
(automatic):
6. Storage
To put into storage:
Disposal:
(in accordance with
RL 2012/19/EU)
20
Working position
v Turn plant guard
until it locks into place.
Switching the trimmer on:
1. Press and hold the safety lock
button
2. Release the safety lock
a
Switching the trimmer off:
v Release the start button
A clean cut is achieved only with the maximum filament
length.
The cutting filament
filament cassette comes to a standstill after switch off.
V
As the filament can only be lengthened in small increments, it can
U
be necessary in some cases to repeat the switch-off / switch-on
action several times (up to 6 times). Important is that the filament
cassette comes to a complete standstill each time.
The cutting filament has been sufficiently lengthened when,
after switch-on, it audibly strikes the filament limiter
The filament cassette has to be replaced (GARDENA Replacement
Filament Cassette Art. No. 5306) when the cutting filament has
been used up.
Store out of the reach of children.
1. Charge battery.
2. Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommendation:
The trimmer can be suspended by the handle.
The trimmer head is not placed upon any unnecessary strain
if stored in a suspended manner.
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
v Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
ö
ö
through 90° into the required position
a
on the handle.
p
again.
a
on the handle.
is lengthened automatically when the
U
ö
Parking position
p
and then press the start
.
V
U
Advertisement
Table of Contents
