Table of Contents
Advertisement
5. Trouble-Shooting
Risk of injury !
Pulling the filament
out of the filament cassette :
E
L
K
E
Fault
The Turbotrimmer
no longer cuts.
If you have any other problems please contact the GARDENA Customer Service.
6. Storage
Overwintering :
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
If a filament is drawn into the filament cassette you can pull it out
again as described below.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 4. Mainte-
nance "Replacing the filament cassette" .
3. Press together the plastic ring
between your thumb and forefinger.
4. Draw the plastic ring
the side part of the filament cassette
if necessary). You can now access the filament that was drawn
into the filament cassette.
5. Unwind the filament
it through the eye of the plastic ring
cessary, loosen the filament beforehand
using a screwdriver. The filament
may stand out max. 2 cm over the knife
6. Pull the plastic ring
filament cassette
7. Reinstall the filament cassette as described
under 4. Mainte-nance "Replacing the
L
filament cassette".
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
Possible cause
Filament worn or too short.
Filament cassette empty.
Filament drawn into the
cassette or stuck together.
The Turbotrimmer must be stored out of the reach of children.
v Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommended storage :
We recommend that you hang your Turbotrimmer from the cable
lock. Hanging storage helps avoid unnecessary stress on the
cutting head.
L
on the filament cassette
L
with the thumb of the other hand over
E
K
approximately 10 cm and thread
L
. If ne-
K
L
back over the
E
.
Remedy
v Lengthen the filament –
see 3. Operation "Filament
feed (Tip mechanism for
automatic filament feed )".
v Replace the filament cassette
– see 4. Maintenance
"Replacing the filament
cassette" ).
v Pull the filament out of the
filament cassette (see above).
E
(use a screwdriver
F
F
.
13
Advertisement
Table of Contents
