Table of Contents
Advertisement
8. Troubleshooting
Risk of injury!
Pulling the cutting filament
manually out of the filament
cassette:
z
37
Releasing a cutting filament
that has gone into the
cassette or which has fused:
Y
z
37
Problem
The trimmer no longer cuts
The filament cannot be
extended
The trimmer does not start
22
Risk of injury from the cutting filament!
v R emove the battery immediately in the event of faults!
A cutting filament that is too short or no longer extends
automatically when the trimmer is turned on can be pulled out
manually.
1. Remove the battery.
2. Hold the automatic slide feed
at the same time pull on the cutting filament
U
If the cutting filament has disappeared into the filament cassette
or if the automatic filament extension still doesn't work after
pulling the cutting filament
filament cassette
1. Remove the battery.
2. Remove the filament cassette
7. Maintenance "Replacing the filament cassette".
3. Unwind the cutting filament
and the cutting filament
X
the cassette
4. Clean the automatic mechanism lever
The automatic lever must move freely.
5. Insert the filament cassette again as described under
7. Maintenance "Replacing the filament cassette".
U
Possible Cause
Filament cassette empty.
Cutting filament too short
or the automatic filament
extension does not work.
Cutting filament inside the
cassette or fused.
The filament became too dry
and brittle (e. g. over the winter).
Battery is flat.
Battery not pushed onto the
handle properly.
Motor blockage.
ß
down with your hand and
37
it may be fused together in the
U
.
Y
as described in
Y
, clean the filament cassette
U
and wind the cutting filament
U
once more.
Y
Remedy
v R eplace the filament cas sette
(see 7. Maintenance
"Replac ing the filament
cassette" ).
v P ull the filament out of the
cassette manually.
v R elease filament that has
disappeared into the cassette
or fused together.
v P lace the filament cassette in
lukewarm water for approx.
10 hours.
v Charge battery
(see 4. Initial Operation).
v Push battery onto the handle
and make sure that the locking
buttons snaps in correctly.
v Unblock and restart the device.
.
U
Y
onto
U
ß
.
37
Advertisement
Table of Contents
