Siemens ET 200iSP Product Information page 12

English A5E51354373-AA
• It is therefore permitted to remove and insert the interface
module during running operation in Zone 1 and Zone 2.
The housing (Ex e / IP 54) in which the ET 200iSP is
located may only be opened briefly (see ET 200iSP
manual).
• When configuring the ET 200iSP, you must observe the
permissible number of electronic modules (see ET 200iSP
manual, chapter 4.6 Limitation of connectable electronic
modules).
• Note: It is not allowed to plug a DP connector at the TM
module.
Commissioning
• The national regulations must be observed during
commissioning.
• Always observe the guidelines according to EN 60079-17
when performing functional checks. This standard also
contains the directives of the international standard
according to IEC 60079-17.
For use in the USA and Canada
The Control Drawing for the ET 200iSP system is supplied
with the power supply module- You can also find the latest
issue at
https://support.industry.siemens.com/cs/ww/en/
Reference A5E00455287.
English