Huawei ATN 950B Hardware Description page 120

ATN 950B Multi-service Access Equipment
Hardware Description
l
l
SC/PC Fiber Connector
Figure 9-20
Figure 9-20 SC/PC fiber connector
To insert or remove an SC/PC fiber connector, do as follows.
l
l
Issue 03 (2012-07-23)
To insert the fiber jumper into the FC/PC connector, align the head of the fiber jumper with
the optical interface on the optical interface board carefully, to avoid any damage to the
internal ceramic pipe. After inserting the fiber jumper to the bottom of the optical interface,
clockwise rotate the external screw to tighten the fiber jumper into the optical interface.
To remove the fiber jumper, first anticlockwise rotate the external screw of the optical
interface. When the screw is loosened, remove the fiber jumper with proper force from the
optical interface.
shows the appearance of the SC/PC fiber connector.
To insert the fiber jumper into the SC/PC connector, align the head of the fiber jumper with
the optical interface and then push the fiber jumper with proper force into the connector.
To remove the fiber jumper, press the clip first, push the fiber connector inward slightly,
and then pull out the connector.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Cables
111