Table of Contents
Advertisement
6 CONTROLS
6.9
6.10
6.11
18
Start button
F03497-10
Combination switch (FE 350 EU)
H02887-01
Overview of indicator lamps
F03498-01
1
Start button
is fitted on the right side of the handlebar.
Possible states
•
The start button
is in the basic position
is pressed – The starter motor is actuated
•
The start button
in this position.
The combination switch is fitted on the left side of the handlebar.
Possible states
STANDARD – STANDARD mapping is activated
1
when LED 1 lights up.
STANDARD with TC – STANDARD mapping with
1TC
traction control is activated when LED 1 and TC light
up.
ADVANCED – ADVANCED mapping is activated,
2
when LED 2 lights up.
ADVANCED with TC – ADVANCED mapping with
2TC
traction control is activated when LED 2 and TC light
up.
Warning
Voiding of the government approval for road use and
the insurance coverage If the combination switch is
mounted, the vehicle's road permit, if any, expires.
–
Only operate the vehicle in closed-off areas remote
from public road traffic if the combination switch is
installed.
The engine characteristic can be changed using button MAP on
the combination switch.
The traction control can also be activated via the combination
switch.
Possible states
The high beam indicator lamp lights up blue – The
high beam is switched on.
Malfunction indicator lamp lights up/flashes yellow
– The OBD has detected an error in the vehicle elec-
tronics. Come safely to a halt, and contact an autho-
rized Husqvarna Motorcycles workshop.
The fuel level warning lamp lights up yellow – The
fuel level has reached the reserve mark.
Turn signal indicator lamp flashes green – The turn
signal is switched on.
Advertisement
Table of Contents
