Brake System 13; Adjusting The Basic Position Of The Hand Brake Lever; Checking Brake Discs - Husqvarna FE 350 2023 Owner's Manual

13.1

Adjusting the basic position of the hand brake lever

13.2

Checking brake discs

Warning
Danger of accidents Worn-out brake discs reduce the braking effect.
–
Make sure that worn-out brake discs are replaced immediately. (Your authorized Husqvarna Motor-
cycles workshop will be glad to help.)
–
Adjust basic position of the hand brake lever to your hand
size by turning adjusting screw
Info
Turn the adjusting screw clockwise to increase the
distance between the hand brake lever and the han-
dlebar.
Turn the adjusting screw counterclockwise to
decrease the distance between the hand brake lever
and the handlebar.
F03506-10
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not
apply any force.
Do not make any adjustments while riding.
–
Check front and rear brake disc thickness at multiple points
for the dimension
Info
Wear reduces the thickness of the brake disc around
the contact surface of the brake linings.
Brake discs - wear limit
front
400257-10
rear
» If the brake disc thickness is less than the specified value:
–
Change the front brake disc.
–
Change the rear brake disc.
–
Check front and rear brake discs for damage, cracking, and
deformation.
» If the brake disc exhibits damage, cracking, or deforma-
tion:
–
Change the front brake disc.
–
Change the rear brake disc.

BRAKE SYSTEM 13

1
.
A
.
2.5 mm (0.098 in)
3.5 mm (0.138 in)
85