Sanuvox P900 Instruction Manual

Sanuvox P900 Instruction Manual

Portable uv air purifier residential/commercial model
Hide thumbs Also See for P900:

Advertisement

Quick Links

REGISTER
YOUR WARRANTY
READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS PRODUCT.
Read and follow all instructions contained in the manual before using the product. Read the maintenance instructions before opening the UV unit
or system. Failure to comply with these instructions may result in injuries or damage to the UV unit or system.
1.
Installation and servicing of UV units or systems (in an
air conditioning system or not) can be hazardous. Only
trained and qualified service personnel should install,
repair or service equipment.
2.
Untrained personnel can perform basic maintenance
functions such as replacing lamp(s) and/or filter(s). All
other operations should be performed by trained service
personnel.
3.
The unit is not to be used by persons (including children)
with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge.
CAUTION: Unit is not a toy. Keep away from
unsupervised children. Do not leave children unattended
with the unit.
4.
DO NOT hang onto the UV unit or system.
5.
Some UV units or systems could be heavy: Make sure
you have a minimum of 2 people to safely move or install
these UV units or systems, and make sure you adopt the
most ergonomic position possible (use UV unit or system
handles, if applicable).
CAUTION: Installing or maintaining heavy equipment,
especially overhead, can cause back pain or other injuries.
6.
When installing or servicing an overhead UV unit or system,
be careful not to fall off the stepladder. Furthermore, make
sure the UV unit or system latches are always in place to
prevent falling parts.
CAUTION: Some parts of some UV units and systems
may open suddenly if the UV unit or system is installed
high up without its locks.
7.
Units that are obviously damaged must not be operated.
8.
CAUTION: When working on the UV unit or system,
observe precautions on the literature, tags and labels
attached to the UV unit or system, and all other safety
precautions considered as best practices in the HVAC
industry, if applicable.
Installation Date: _______________
Installer Contact Info.: _________________________________________
P900
PORTABLE UV AIR PURIFIER
Residential / Commercial Model

IMPORTANT SAFETY INSTRUCTIONS

NEVER EXPOSE EYES OR SKIN TO AN OPERATING UV LAMP.
9.
When applicable, local regulation may comprise more
restrictive installation and/or certification requirements.
The aforementioned requirements prevail on those of this
document and the installer agree to conform to these at his
own expense.
10. Follow all the safety instructions outlined in this document
and respect all local and national codes applicable.
11. All UV units or systems contain a UV-C source. Damage to
the housing or unintended use of the UV unit or system may
result in harmful UV-C leaks. UV-C may, even in little doses,
cause harm to the eyes and skin.
12. Never expose eyes or skin to an operating UV lamp.
Therefore, before installing or performing maintenance
on the UV unit or system, TURN OFF AND DISCONNECT
the UV unit or system from all power sources (there
may be more than one switch to disconnect) and also
disconnect the HVAC system, is applicable.
CAUTION: Electrical shock may cause injuries or
possibly death. FIRST AID INSTRUCTIONS: If injured,
consult a doctor.
12.1. To reduce the risk of electric shock, this equipment has a
grounding type plug that has a third (grounding) pin. This
plug will only fit into a grounding type power outlet. If the
plug does not fit into the outlet, contact qualified personnel
to install the proper outlet. Do not alter the plug in any way.
13. UV rays may damage certain types of filters (polymer or
plastic); please keep the UV unit or system light away from
shining directly on plastic.
14. When installing or performing maintenance on the UV unit
or system, it is recommended to wear safety gloves. In
order to avoid reduced performance of lamp(s), do not
touch lamp glass without gloves.
Sanuvox Technologies Inc, © 2019 All rights reserved. August 2023 EN v.9
15. Just like conventional fluorescent lamps, UV lamps contain
a small quantity of mercury: if a lamp breaks, clean and
dispose of with care. UV lamps can be disposed/recycled
after use in the same way as any other fluorescent lamps.
Contact and follow the specific instructions of your local
and national authorities.
15.1. Dispose of unit or system according to the specific
instructions and standards of your local and national
authorities.
16. Use only specified SANUVOX branded replacement
UV lamps for your UV unit or system. Use of any other
lamps will void your warranty and can result in damage to
the UV unit or system.
17. Sanuvox UV units or systems are not waterproof. DO NOT
INSTALL OUTDOORS OR IN WET LOCATION unless
specified otherwise.
18. Use of this unit or system supplements, but does not
replace, infection control best practices. Users must follow
all these practices, particularly with regard to cleaning and
disinfecting surfaces.
For any inquiries on a UV unit or system, contact :
Installed by: _________________
Instruction Manual
SAVE THESE INSTRUCTIONS
Robert Smith
146 Barr St, Saint-Laurent
Quebec, CA, H4T 1Y4
1-888-726-8869
techsupport@sanuvox.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P900 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sanuvox P900

  • Page 1: Important Safety Instructions

    UV unit or system, and all other safety precautions considered as best practices in the HVAC industry, if applicable. Installation Date: _______________ Installed by: _________________ Installer Contact Info.: _________________________________________ Sanuvox Technologies Inc, © 2019 All rights reserved. August 2023 EN v.9...
  • Page 2: Table Of Contents

    Instruction Manual for P900 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS TABLE OF CONTENTS ABOUT THE PRODUCT COMPONENTS How it Works SETUP & INSTALLATION What you will need What’s included Step by Step Setup & Installation Step by Step Stand Installation...
  • Page 3: About The Product

    How it Works Foul air enters the P900 parallel to the UV ‘J’ lamp, thus increasing contact time with the UV light. First, the air goes through an inlet filter that captures particles. After, the UV lamp attacks biological contaminants. Finally, the purifed air circulates through the home.
  • Page 4: Setup & Installation

    See Stand and Handle Installation instructions on page 5. STEP 3 3. Replace the P900 upright or on wall and plug the purifier in a wall outlet. You are now ready to power ON your new P900 and enjoy great air quality.
  • Page 5: Step By Step Stand Installation

    Instruction Manual for P900 Step by Step Stand Installation STEP 1 1. Loosen the two bottom screws between the two rubber feet. STEP 2 2. Slide the stand through the two screws and tighten. Step by Step Handle Installation STEP 1 1.
  • Page 6: Operation

    How to Operate your Product The P900 is an automatic unit: once it’s installed and plugged in, simply press the power switch to turn it ON and enjoy clean air! CAUTION: The suggested operating temperature range is 10 to 50°C (50 to 122°F). Operating the P900 outside this range will result in decreased performance.
  • Page 7: Step By Step Adjust Fan Speed

    How to Replace Lamp(s) Replacing lamp on the P900 is quick and easy. Simply turn off the power source, remove and dispose of old lamp, replace with new Sanuvox branded UV lamp, turn power source back on. See below for detailed step by step instructions.
  • Page 8 It may be necessary to rotate the plug 90° to attach it. STEP 8 8. Replace the lamp access door and secure it with its 4 screws. STEP 9 9. Replace the P900 upright or on wall and plug the purifier in a wall outlet. www.sanuvox.com 1-888-726-8869...
  • Page 9: How To Clean Your Product

    Instruction Manual for P900 How to Clean your Product For optimal performance, the lamp(s) and filter(s) should be kept free of dust and residue deposit. Clean when necessary with mild soap or alcohol. To clean the unit exterior, use a damp cloth with general purpose detergent. Always spot test the cleaner to make sure it does not damage the surface.
  • Page 10: Storage

    ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE The P900 has a power consumption of 33W. The product is rated at 120V to 240V, and 50 Hz to 60 Hz. See product label to confirm power consumption of your specific unit or system.
  • Page 11: Step By Step Verification Of Motor Wire Connection

    TURN OFF AND DISCONNECT the unit or system from all power sources. STEP 2 2. On the back of the P900, unscrew the 8 screws along the sides (4 on the left, and 4 on the right) to open the unit. STEP 3 3.
  • Page 12: Warranty

    This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, SANUVOX will repair or replace this product if it is found to be defective in material or workmanship.

Table of Contents