wsm 03-CR-E4 Workshop Manual page 92

Diesel engine
Table of Contents

Advertisement

 CHECK AND MAINTENANCE
9. Check points of every 3000 hours
• When installing and removing the muffler full
assembly (DPF), make sure that the temperature
sensor,
differential
differential pressure pipe do not make contact
with surrounding parts.
Tools required
• Crowfoot wrench
1. Disconnect the harness of exhaust gas temperature
sensor from the connector (7), (8), (9) and the
harness of differential pressure sensor (10).
2. Remove the connector of exhaust gas temperature
sensor (7), (8), (9) from the bracket.
3. Remove the clamp (5).
4. Remove the tube (11), (12) from the differential
pressure pipe (1), (4).
5. Remove the differential sensor (3).
6. Remove the differential sensor bracket (2).
7. Remove the 4 screws of muffler flange (6).
(1) Differential pressure pipe
(2) Differential pressure sensor
bracket
(3) Differential pressure sensor
(4) Differential pressure pipe
(5) Clamp
(6) Muffler flange
(7) Connector of exhaust gas
temperature sensor (T
)
2
8. Remove the muffler full assembly (DPF) mounting
screws (13).
9. Remove the muffler full assembly (DPF) (14).
03-CR-E4,03-CR-TE4BG
pressure
sensor,
and
(8) Connector of exhaust gas
temperature sensor (T
)
1
(9) Connector of exhaust gas
temperature sensor (T
)
0
(10) Differential pressure sensor
connector
(11) Tube
(12) Tube
(13) Muffler full assembly (DPF)
mounting screw
10. Loosen the Filter comp (DPF) bracket (15), (17) and
remove the Filter comp (DPF) (16).
(15) Filter comp (DPF) bracket
(16) Filter comp (DPF)
11. Pack the filter comp (DPF) (16) and send it to a
cleaning contractor.
3. MAINTENANCE
(14) Muffler full assembly (DPF)
(17) Filter comp (DPF) bracket
3-21
KiSC issued 02, 2021 A

Advertisement

Table of Contents
loading

This manual is also suitable for:

03-cr-te4bg

Table of Contents