Removing Bearing Case Cover; Removing Crankshaft (For 3 Cylinders) - wsm 03-CR-E4 Workshop Manual

4. ENGINE

5.39 Removing bearing case cover

NOTE
• Before disassembling, check the side clearance
of crankshaft. Also check it after reassembling.
1. Remove the inner mounting screws of bearing case
cover (1).
2. Remove the external mounting screws of bearing
case cover (2).
NOTE
• The length that inner mounting screws of
bearing case cover
mounting screws of bearing case cover (2)
are different.
(1) Inner mounting screw of
bearing case cover
3. Remove the bearing case cover (3).
(3) Bearing case cover
5.40 Removing crankshaft (for 3
cylinders)
NOTE
• Before you disassemble, measure the side
clearance of crankshaft. Measure it when you
assemble again.
4-132
(1) and external
(2) External mounting screw of
bearing case cover
• This topic is used for only 3 cylinders engine
(D1803-CR-E4, -TE4, -TIE4, -TIE4BG).
1. Remove the main bearing case mounting screw 2
(1).
(1) Main bearing case mounting
screw 2
2. Turn the crankshaft to set the crankpin of the third
cylinder to the bottom dead center.
3. Pull out the crankshaft until the crankpin of the
second cylinder comes to the center of the third
cylinder.
4. Turn the crankshaft
counterclockwise to set the crankpin of the second
cylinder to the bottom dead center.
SERVICING
5. Disassembling
by 2.09 rad (120°)
03-CR-E4,03-CR-TE4BG
KiSC issued 02, 2021 A