Table of Contents
Advertisement
Installation warnings.
•
Voltage regulator must have sufficient air cooling: check its position carefully.
•
When voltage regulator is used without battery it will fail: connections to battery must
be solid, use quality battery.
•
When voltage regulator is reverse connected to battery, it will fail.
•
The minimum cross-section of the cables that connect the battery to the starter motor
must be of 6 mms² and their length must never exceed 600 mms.
Installation advice.
Place the start button in a position where it is not possible to be pressed accidentally:
•
Accidental start of the engine can be a risk for the user and can lead to severe injury.
•
Whenever this happens while the engine is revving higher than idle the electric starter
may be damaged.
Check that voltage regulator works within regulations limits after installation.
An example of the installation position of the plate with the 2 coils and the CDI is given in the figure.
Cosmos 300 - Installation manual - V3
32
Advertisement
Table of Contents
