Specifi Cations - NEC MD211G3 Installation & Maintenance Manual

Specifi cations
Monitor Specifi cations
LCD Module
Viewable Image Size:
Native Resolution (Pixel Count):
Input Signal
DisplayPort: DisplayPort Connector:
DVI: DVI-D 24pin:
Display Tones
Synchronization Range
Clock Frequency
Viewing Angle
Image Formation Time
Resolutions Supported (Some systems may
not support all modes listed).
Active Display Area Landscape: Horiz.:
Portrait: Horiz.:
USB Hub
Load Current:
Power Supply
Current Rating
Dimensions
Height Adjustment:
Weight
Sensor Accuracy and Repeatability
Front Sensor
Repeatability:
Ambient Sensor
Repeatability:
Environmental Considerations
Operating Temperature:
Atmospheric pressure:
Transport/Storage Temperature:
Atmospheric pressure:
At 25 degrees, Target Brightness 400cd/m
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and
necessary for all current fl at panel technologies when displaying non-native resolutions full screen. In fl at panel technologies, each dot on the screen is actually one
pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifi cations are subject to change without notice.
MD211G3 Monitor
Diagonal: 54.0 cm/21.3 inches
54.0 cm/21.3 inches
1536 x 2048 (Portrait)
2048 x 1536 (Landscape)
Digital RGB
Digital RGB
10bit: 1024 (10bit) shades of gray from a
pallet of 48961 (15.5bit)
8bit: 256 (8bit) shades of gray from a pallet of
48961 (15.5bit)
Horizontal: 31.5 kHz to 99.4 kHz, 126.3 kHz
Vertical: 30 Hz, 50 Hz to 85 Hz
214.3 MHz (Max)
Left/Right: ±88° (CR > 10)
Up/Down: ±88° (CR > 10)
27 ms (Typ.)
640 x 480* 1 at 60 Hz to 85 Hz
1
720 x 400* at 70 Hz to 85 Hz
800 x 600* 1 at 56 Hz to 85 Hz
1024 x 768* 1 at 60 Hz to 85 Hz
1280 x 1024* 1 at 60 Hz to 85 Hz
1600 x 1200* 1 at 60 Hz to 75 Hz
1
1920 x 1200* at 60 Hz
2048 x 1536 at 30 Hz to 60 Hz (Reduced Blanking)
2048 x 1536 at 60 Hz (Reduced Blanking)........... NEC DISPLAY SOLUTIONS recommended resolution
1024 x 1280 at 60 Hz*
1200 x 1600 at 60 Hz*
1536 x 2048 at 60 Hz (Reduced Blanking)........... NEC DISPLAY SOLUTIONS recommended resolution
433.2 mm/17.1 inches
Vert.: 324.9 mm/12.8 inches
324.9 mm/12.8 inches
Vert.: 433.2 mm/17.1 inches
I/F: USB Specifi cation Revision 2.0
Port: Upstream 1
Downstream 2
Maximum 0.5A per port
AC 100-240 V ~ 50/60 Hz
1.2 - 0.46 A
Landscape: 467.8 mm (W) x 377.6 - 527.6 mm (H) x 227.6 mm (D)
18.4 inches (W) x 14.9 - 20.8 inches (H) x 9.0 inches (D)
Portrait: 361.6 mm (W) x 483.4 - 580.7 mm (H) x 227.6 mm (D)
14.2 inches (W) x 19.0 - 22.9 inches (H) x 9.0 inches (D)
150 mm/5.9 inches
10.7 kg (23.6 lbs)/Without stand: 7.5 kg (16.5 lbs)
Accuracy: +/-10% (Lv>10cd/m
+/-2%
Accuracy: +/-10%
+/-5%
5°C to 35°C/41°F to 95°F
Humidity: 30% to 80%
Altitude: -1,246 to 9,842 Feet/-380 to 3,000 m
700hPa to 1060hPa
-10°C to 60°C/14°F to 140°F
Humidity: 10% to 85%
Altitude: -1,246 to 39,370 Feet/-380 to 12,000 m
200hPa to 1060hPa
2
Notes
Active matrix; thin fi lm transistor (TFT) liquid crystal
display (LCD); SA-SFT (IPS) 0.212 mm dot pitch;
1450 cd/m
luminance; 900:1 contrast ratio (typical).
DisplayPort Complies with Standard V1.1a,
applicable to HDCP
DVI
When used with a NEC approved 10bit display
controller
When used with a NEC approved 8bit display
controller
Automatically
Automatically
13 ms (Gray to gray Typ)
1 for optimal display performance.
1
for optimal display performance.
For Mexico 2.0A
2 ), +/-1cd/m 2 (10cd/m 2 ≧ Lv>2cd/m
(Standard Deviation)
(Light source: Fluorescent Lamp, Distance: 58 cm,
Angle: 25 +/-5 degrees from the vertical axis of the
ambient sensor).
(Same as Accuracy conditions).
English-21
2
max luminance; 400 cd/cm
2 ), +/-0.5cd/m 2 (Lv ≦ 2cd/m 2 )
2
calibrated