Intended Use The MD21GS-3MP grayscale display is intended to be used for displaying and viewing of digital images for diagnosis by trained physicians. To guarantee the display performance as specified, it must only be used in conjunction with NEC recommended controller boards as specified in the Installation and Maintenance manual for this model.
Page 4
CAN/CSA C22.2 No. 601.1. FCC Information 1. Use the attached specified cables with the MD21GS-3MP grayscale display so as not to interfere with radio and television reception. (A) Please use the supplied power cord or equivalent to ensure FCC compliance.
Contents Your new NEC Display monitor box* should contain the following: • MD21GS-3MP Display with tilt/swivel/pivot/height adjustable stand • Power Cords (N.A. Hospital Grade, Europe Continental and Chinese • Quick Reference & Setup Guide • Installation and Maintenance Guide • CD-ROM (GammaComp MD) •...
Quick Start Optional Display Card Installation 1. Following your PC manufacturer’s guidelines, open your computer to access a PCI slot. 2. Place the display card into an available PCI slot and secure all screws. 3. Replace the computer cover. NOTE: For installing driver information, display modes in multimonitor mode, the setting the dip switch, please reference the display card manufacturer’s documentation.
Page 8
User Controls Indicates power on and signal condition. The LED can be turned on, 1. LED off, or dimmed. Please refer to the Advanced OSM section/LED Brightness for further information. Green – signal is present and power is on Orange – no signal 2.
NOTE: As with all personal display devices, NEC-Mitsubishi Electronics Display recommends using a moving screen saver at regular intervals whenever the screen is idle or turning off the display when not in use.
Page 10
Recommended Use CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE DISPLAY: • For optimum results during self and copy calibrations, allow 30 minutes for warm-up. • Adjust the display height so that the top of the screen is at or slightly below eye level.
(LCD); 0.2115 mm dot pitch; 400 cd/ m calibrated white luminance; 700:1 contrast ratio, typical. VideoDot Clock 162MHz Max When used with an NEC recommended 10 bit video card When used with an NEC recommended 8 bit video card Automatically...
References North America and Canada NEC-Mitsubishi Monitor Customer Service & Support Customer Service and Technical Support: Fax: Parts and Accessories/Macintosh Cable Adapter: Warranty Information: Online Technical Support Sales and Product Information Sales Information Line: Canadian Customers: Government Sales: Government Sales email:...