NEC MD211G3 Installation & Maintenance Manual page 17

FACTORY PRESET
Selecting Factory Preset allows you to reset all OSD control settings (LUMINANCE, IMAGE CONTROL, PICTURE
MODE, SHARPNESS, OFF MODE, OSD LEFT/RIGHT, OSD UP/DOWN, OSD TURN OFF) back to the factory
settings. Individual settings can be reset by highlighting the control to be reset and pressing the RESET button.
Information
Provides information about the current resolution display and technical data including the preset timing being used and
the horizontal and vertical frequencies. Indicates the model name and serial number of your monitor.
OSD Warning
OSD Warning menus disappear by pressing the EXIT button.
NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power is turned on or
when there is a change of input signal, the No Signal message window will appear.
OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After power
is turned on or there is a change of input signal or if the video signal doesn't have proper timing, the Out Of Range
message window will appear.
BACKLIGHT LIFETIME: At 1000/500/0 hours of estimated remaining backlight lifetime, a warning message will be
displayed. Please contact your supplier when this warning message is displayed.
LUMINANCE WARNING: This warning indicates that the monitor cannot keep user set luminance levels. Please
contact your supplier when this warning message is displayed.
If you need detailed information about the controls, please refer to the ADVANCED OSD menu.
English-15