Installing the GX 550 ES Extender
Rack-mounting the GX 550 ES Extender
Flush-mount Installation in a 19-inch Equipment Rack
The GX 550 ES extender is delivered with mounting flanges built in to its front for
flush-mounting in a 19-inch equipment rack. Follow the steps below to install the
GX 550 ES extender in the equipment rack:
1. Raise the GX 550 ES to the appropriate installation height, using a hand lift (or a
minimum of two installers).
2. Position the GX 550 ES in the equipment rack, lining up four screw holes in the
right mounting flange with four screw holes on the right side of the equipment
rack as shown in
4-44/5/03
Ex. 2006
Beta Draft Confidential
Figure 4-1 on page
4-5.
GX 550 ES Hardware Installation Guide
000068