Operation; Transport And Storage; Preparation - Promeba PA210-O User Manual

USER GUIDE
SPINE BOARD

06 OPERATION

06.1.

Transport and storage

Before transporting the device, make sure that it is
correctly packaged.
During transport always fix the load. If piling up is
necessary always follow the scheme shown on
figure 1.
Transport the leveled load and following all precepts
and rules for the transport of loads, ensuring also
that there are no risks of shocks, bumps or falls
during the transport itself.
To unpack the device place the box on a flat, stable
surface and carefully open the seal. Remove the
device from the inside of the box following the
scheme shown on figure 2. Keep the original
packaging for use in case of any further transport
and for storage.
Damage to the device caused during transport and
handling is not covered by the guarantee. Repairs or
replacement of the damaged parts are the
responsibility of the client.
The device must be stored in a dry, cool area away from direct sunlight. It must not be placed
in contact with any substances or chemical agents which could cause damage and reduce
safety characteristics.
The storage temperature must be between -20ºC to 40ºC.
The product must not be manipulated in any way (modification, adjustment, addition,
substitution). In such cases, all responsibility for any malfunction or injury caused by the
product itself will be disclaimed; furthermore, CE certification and product warranty will be
considered void.
06.2.

Preparation

On receipt of the product:
- Remove the packaging and display the material so that all components are visible.
- Check that all the components/pieces on the accompanying list are present.
The appliance must be checked before every use so as to reveal any working abnormalities
and/or damage caused by transport and/or storage. In particular, check:
- General functionality of the device.
- Cleanliness of the device (remember that the failure of cleaning may cause the risk
of cross infections).
- Absence of cuts, holes, tears on the structure, including the straps.
- Integrity of components.
EN
REV. 2023/05
44