Trigger Alarm Output; Configure Audio And Light Alarm Linkage; Configure Ptz Linkage - HIKVISION DS-8600NXI-I8/S Series User Manual

detected.
Steps
1. Go to System → Network → Advanced → Email.
2. Set the email parameters.
3. Click Apply.
4. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
5. Select Send Email alarm linkage action.

5.4.5 Trigger Alarm Output

The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any all other events.
Steps
1. Go to Linkage Action of the alarm detection (e.g., motion detection, face detection, line
crossing detection, intrusion detection, etc.).
2. In Trigger Alarm Outputs, select the alarm output(s) to trigger.
3. Go to System → Event → Normal Event → Alarm Output.
4. Select an alarm output item from the list.

5.4.6 Configure Audio and Light Alarm Linkage

For certain network cameras, you can set the alarm linkage action as audio alarm or light alarm.
Before You Start
● Ensure your camera supports audio and light alarm linkage.
● Ensure the audio output and volume are properly configured.
Steps
1. Go to the linkage action interface of the alarm detection (e.g., motion detection).
2. Set Audio and Light Alarm Linkage as your desire.
3. Click Apply.

5.4.7 Configure PTZ Linkage

The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event, or
VCA detection events occurs.
Before You Start
Make sure the connected PTZ or speed dome connected supports PTZ linkage.
Steps
1. Go to Linkage Action interface of the alarm input or VCA detection (e.g., face detection, line
crossing detection, intrusion detection, etc.).
Network Video Recorder User Manual
93