HIKVISION DS-8600NXI-I8/S Series User Manual page 32

No.
13 PTZ
14 ESC
15 RESERVED
16 F1
17 PTZ Control
18 F2
Troubleshooting Remote Control
If the Status indicator on the front panel turns blue, the remote control is
operating properly. If the Status indicator does not turn blue and there is
still no response from the remote, please check the following:
● Batteries are installed correctly and the polarities of the batteries are not reversed.
● Batteries are fresh and not out of charge.
● IR receiver is not obstructed.
● No fluorescent lamp is used nearby.
If the remote still can't function properly, please change a remote and try
again, or contact the device provider.
Steps
Note
● Make sure you have installed batteries properly in the remote control. And you have to aim
the remote control at the IR receiver in the front panel.
● If there is no response after you press any button on the remote, follow the procedure below
to troubleshoot.
1. Go to Menu → Settings → General → More Settings by operating the front control panel or the
mouse.
2. Check and remember NVR ID#. The default ID# is 255. This ID# is valid for all the IR remote
controls.
3. Press DEV on the remote control.
4. Enter the NVR ID# you set in step 2.
Network Video Recorder User Manual
Name
mode
Stop/start auto switch in auto-switch mode
Enter PTZ Controlmode
Go back to previous screen
N/A
Reserved
Select all items on a list
N/A
Switch between play and reverseplay in Playback mode
Adjust PTZcamera iris, focus, and zoom
Cycle through tabpages
Switch between channels in Synchronous Playback mode
FunctionDescription
13