Finishing The Fuselage - Krick Habicht Building Instruction

3.4 The canopy R-24 is cut to size and adapted to the fuselage and frame. To glue it to the canopy, press the
frame as far as possible into the canopy, but do not push the canopy apart. The frame must also not be
twisted. After the adhesive has hardened, carefully cut away any excess canopy material and grind it flat
with the frame.
3.5 After gluing in the magnets R-25 with 5min. epoxy - pay attention to the polarity of the magnets! - the
canopy can be finally adapted to the fuselage. The edges of the canopy can be sanded a little, as they will
be covered with coloured foil or painted later.
4.

Finishing the fuselage

4.1 The fuselage is now sanded with sandpaper and sanding block. Slightly round off the corners and sand
the surfaces completely.
4.2 Now the two dowels R-26 for the wing fixing
are glued in place. Cut the rod to 80 and 60 mm.
Round off the four ends slightly. When gluing in,
make sure that the dowels on the left and right
protrude equally.
R-24
© Klaus Krick Modelltechnik, Knittlingen, Germany
R-26
7