Changing Coffee Temperature; Changing The Length Of Time The Appliance Remains On; Setting Water Hardness; Resetting Factory Default Settings - Whirlpool ACE 100 IX Instructions For Use Manual

12.4 Changing coffee temperature

To change the temperature of the coffee, proceed as follows:
• Press the button (the light over the button comes on) then press the
the appliance displays:
• Press the
• Press the button to confirm the temperature selected;
• Press the

12.5 Changing the length of time the appliance remains on

The appliance is factory preset to go off automatically one hour after the last coffee has been made.
The number of hours the appliance remains on can be increased as follows:
• Press the
the appliance displays:
• Press the
• Press the button to confirm the value;
• Press the

12.6 Setting water hardness

The descale message is displayed after the appliance has been operated for a factory set period of time cal-
culated on the basis of the maximum quantity of lime scale which may be contained in the water used. If
necessary, this period of operation can be extended, making descaling less frequent, by programming the
appliance based on the actual lime content in the water used. Proceed as follows:
• Remove the "Total Hardness Test" strip (enclosed on page 2) from its packaging then dip it fully in the
water for a few seconds, Remove it and wait around 30 seconds (until it changes colour and a number
of red dots are formed);
• Turn the appliance on by pressing the
• Press the
• Press the
test strip (for example, if there are 3 red squares on the test strip, press the button until WATER HARD-
NESS 3 is displayed).
• Press the button to confirm the value. The coffee maker is now programmed to provide the desca-
ling warning when necessary, based on the actual hardness of the water.

12.7 Resetting factory default settings

If you change the original values, the factory default values can be reset as follows:
• Press the
• Press the
• Press the button to reset the factory default values;
• Press the
36
TEMPERATURe MEDIum
button until the appliance displays the required coffee temperature
button to exit programming mode or
button (the light over the button comes on) then press the
button to change the number of hours the appliance remains on
button to exit programming mode or
button then press the
WATER HARDNESS 4
button repeatedly until the number coincides with the number of red squares on the
, button then press the
RESET TO DEFAULT NO
button and the appliance displays "RESET TO DEFAULT YES";
button to exit programming mode or
OFF AFTER 1 HOUR
button (fig. 4).
button repeatedly until the appliance displays:
button repeatedly until the appliance displays:
button repeatedly until
to change other parameters.
button repeatedly until
to change other parameters.
to change other parameters